Screws for the ball pocket

These screws are specifically designed to secure the storage pack or other accessories to the perimeter slots of the steel or aluminum plate. They are a key component for those seeking a clean, hydrodynamic setup free of dangerous protrusions.

Key Features:

• Material: Entirely made of AISI 316 stainless steel (marine grade). This material is chosen for its exceptional resistance to galvanic corrosion and rust, ensuring that the screws will not seize up even after years of use in saltwater.
• Low-Profile Design: The heads of the screw and nut are flat or slightly rounded. This design is essential for:
• Comfort: Prevent the screw from pressing against the diver's back through the wetsuit.
• Protection: Prevent sharp edges from scratching or cutting the BCD bag or the wetsuit itself.
• Screw-and-Pin System (Male/Female): The set consists of an internally threaded pin (female) and a screw (male). Once tightened, they create an extremely secure mechanical lock that is not affected by vibrations.
• Ease of Installation: They typically feature a slot (either a straight or cross-shaped one) on both sides to allow tightening with standard screwdrivers or coins.

Common Applications:

• Storage Pack Mounting: Attaching the rear pocket for the marker buoy or lift bag to the edges of the backplate.
• Accessory Mounts: Used to attach fixed weight pockets, battery plates for torches, or mounts for knives and line cutters to the BCD frame.
• Technical Setups: Ideal for those who follow the DIR standard or use side-mount setups that require flat, secure attachment points.